WinReducer.net Project
Would you like to react to this message? Create an account in a few clicks or log in to continue.

WinReducer.net ProjectLog in

FORUM

descriptionload current settings from install.wim for Features and services Emptyload current settings from install.wim for Features and services

more_horiz
hi winter,

i was thinking a bit at work and thought about the feature and service tab in winreducer. and i thought why the features and services do not show the actual settings (Enable, disable etc)?

im not sure but i think i saw at the features that that some components are greyed out. so winreducer is looking them up? i found this article

[You must be registered and logged in to see this link.]

and with the switch "/get-features" you can look up if the features are disabled or enabled. so it would be nice to also display that on winreducer.

i also found this for services, which you probably already know to set the service to i.e. Disable:

[You must be registered and logged in to see this link.]

so also there it would be nice to see the status


EDIT: C&P a PN i wrote to winterstorm, just posted this thread so this wont be forgotten

descriptionload current settings from install.wim for Features and services EmptyRe: load current settings from install.wim for Features and services

more_horiz
Hello,

I disabled this Features and Services detection in October 2016, in order to solve troubles with access rights related files.

I will re-enable the Features and Services detection in the next WRSEB builds (it should be next week).
privacy_tip Permissions in this forum:
You cannot reply to topics in this forum